The third character in the code identifies the system where the fault occurred. Numbers 1 and 2 are for fuel or air metering problems, 3 is for ignition problems or engine misfire, 4 is for auxiliary emission controls, 5 relates to idle speed control problems, 6 is for computer or output circuit faults, and 7 and 8 relate to transmission problems.



Codes can be accessed and cleared using an Car Diagnostic Tool such as AutoTap.
MISFIRE DETECTION

If an emissions problem is being caused by engine misfire, the OBD II light will flash as the misfire is occurring. But the light will not come on the first time a misfire problem is detected. It will come on only if the misfire continues during a second drive cycle and will set a P0300 series code.

A P0300 code would indicate a random misfire (probably due to a vacuum leak, open EGR valve, etc.). If the last digit is a number other than zero, it corresponds to the cylinder number that is misfiring. A P0302 code, for example, would tell you cylinder number two is misfiring. Causes here would be anything that might affect only a single cylinder such as a fouled spark plug, a bad coil in a coil-on-plug ignition system or distributorless ignition system with individual coils, a clogged or dead fuel injector, a leaky valve or head gasket.

The OBD2 Scanner system detects a misfire on most vehicles by monitoring variations in the speed of the crankshaft through the crankshaft position sensor. A single misfire will cause a subtle change in the speed of the crank. OBD II tracks each and every misfire, counting them up and averaging them over time to determine if the rate of misfire is abnormal and high enough to cause the vehicle to exceed the federal emissions limit. If this happens on two consecutive trips, the Check Engine light will come on and flash to alert the driver when the misfire problem is occurring.

Posted by: Emily white at 09:49 AM | No Comments | Add Comment
Post contains 344 words, total size 153 kb.